Floorcare P
FLOORCARE P is a two-component, low viscosity, epoxy resin base primer for concrete surface
FLOORCARE P is combination of epoxy resin, hardener & many other additives. It is used for bonding of old to new concrete and also used for repair works, stone works and screeds because it provides strong monolithic bond, very high strength than the parent concrete & sufficient application time to finish the job.
Roads, bridges, pavements, loading bays and factories.
Internal & external applications.
For bonding granolithic floor toppings such as sand cement screed, mortars and epoxy screed.
Used as part of a repair system where a substrate/repair barrier is required.
- All substrate must be structurally sound, dry and free from laitance and loose particles.
- Clean floors of oil, grease and rubber skid marks, paint stains and other adhesion impairing contaminants.
- Mechanical surface profiling by grit or shot blasting, grinding or scarifying are the preferred floor preparation methods.
- The residual moisture content of the substrate must not exceed 4%. A damp-proof course must have been properly installed and intact.
- Substrate temperatures: 150C – 350C, Material temperatures: 150C – 300C.
- Very low or very hot temperatures will make application more difficult and careful consideration should be given to storage of materials.
- In the cold weather conditions, pre- condition materials by keeping it in a heated room. In hot weather conditions, some form of air-conditioned storage is required.
- Pre-conditioned materials at 20-250C will reduce the possibilities of flash/slow setting and other defects.
Properties:
Specific gravity, g/cc
Standards:
Results:
1.09 + 0.02
Properties:
Hardness , shore D
Standards:
ASTM D 2240
Results:
1.15 + 0.02
Properties:
Compressive strength, 7 days, N/mm2
Standards:
BS 6319, Part 7
Results:
65
Properties:
Tensile strength, 7 days, N/mm2
Standards:
BS 6319, Part 7
Results:
15
Properties:
Flexural strength, 7 days, N/mm2
Standards:
BS 6319, Part 7
Results:
35
Dosage & Coverage
Coverage rates will vary according to the nature of the substrate. 1 Kg of Floorcare P shall cover 6 – 8 m2 and provide average 100 μ DFT, depending upon the porosity of the substrate
Shelf Life
Best before 12 months from date of packaging.
Packaging & Storage
- Available in 30 KG composite pack.
- Store in cool, dry & covered environment
Health & Safety Precautions
As with all chemical products, care should be taken during use and storage to avoid contact with eyes, mouth, skin and foodstuffs (which can also be tainted with vapor until product fully cured or dried).
Keep away from children and animals. Reseal containers after use.
Treat splashes to eyes and skin immediately. If accidentally ingested, seek immediate medical attention.
Do not reuse containers for storage of consumable item.