Products > Construction Chemicals > CONCARE ULTRABOND FLEX
Specially formulated acrylic co-polymer emulsion for multiple applications:
1. Can be used a bonding agent for new to old substrates
2. Can be used as a cement mortar modifier which improves tensile & flexural strength.
3. Can be used as an excellent waterproofing coating, especially for wet areas like bathrooms & toilets, balconies and kitchen sink areas when mixed with cement at specified ratio and methodology.
| PARAMETER | TYPICAL VALUE |
|---|---|
| Chloride content | Nil |
| ph @ 30°C | 7 to 8 (ASTM E 70) |
| Adhesion strength | 5-20 N/mm2 (BS 6319 Part2: 1984) |
| Compressive strength | >30N/mm2 (BS 6319 Part2: 1983) |
• Bonding agent between old and new concrete/brickwork/plaster.
• Waterproof coating for internal wet areas before brickbat/tile/stone installation.
• Mortar enhancer for flexural & tensile strengths
• Clean surface of dust, dirt and loose particles.
• Repair spalled/damaged areas by saw cutting and removing weak concrete.
• Roughen smooth surfaces by scrabbling/grit blasting.
• Saturate with clean water, remove excess before application.
• Mix Ultrabond Flex: Cement=1:15 by volume.
• Stir 2-3 minutes to uniform consistency.
• Apply 2 brush coats (interval 4-6 hrs).
• Mix Ultrabod Flex: Cement=1:1 by volume.
• Brush apply 1 coat and overlay mortar while tacky.
• Mix: Cement 10kg, Washed Sand 25 kg, Ultrabond Flex 1.5 kg, Water 1.5-2 L.
• Apply for patch repairs and render works.
Coverage: 5-7 m2/kg
| PARAMETER | TYPICAL VALUE |
|---|---|
| As a Bond Coat | 5-7 m2/Kg |
| As a Waterproofing | 2-2.2 m2/Kg in 2 coats |
| As a mortar enhancer | 1.5 ltrs per 10 Kg of cement |
50 & 20 Ltrs cans
Best before 18 months from date of packaging.
Store in cool, dry & covered environment (5 to 40°C)
Direct contact with skin may cause irritation. Avoid skin contact by using protective gloves. If any contact occurs, wash thoroughly with soap and water.
Should not be inhaled. It is advisable to use a protective respiratory mask of good quality while handling, pouring and mixing the powder.
Avoid contact with eyes by using proper eye protection. If such contact occurs, rinse thoroughly with clean water. If any uneasiness persists, seek medical adivce.
Refer to MSDS for further instructions and precautions.
This will close in 0 seconds
This will close in 0 seconds